Zaxcom Nomad Bedienungsanleitung PDF herunterladen (Seite 77)

NOMAD OPERATIONS Basic ENG / EFP Bag Operations

ENG /EFP Bag Operation

ENG mode was created to aid in mixing and recording when you are involved in a “run and gun” situation.

In ENG mode you can pan and mix all 10 inputs right from the ENG Home screen.

In the ENG Home page you will see:

• Output busses 1 and 2 (Left / Right).

• 10-channel routing matrix where you can “pan” inputs 1-10. You can pan to L (left), R (right) or C (center).

• Input meter that follows AutoTrim.

ENG Panning

The pan routing matrix is essentially a shortcut to the output bus assign matrix. From this matrix you can route

post-fade analog inputs to a pair of outputs busses. When you make a change in the ENG pan routing matrix, it

actually adjusts the routing in the output bus assign matrix.

If you are feeding more than one camera, you may want to add additional pairs to follow the routing. This

means that buses 3 & 4 and 5 & 6 can also be routed to follow the pan routing done on this home screen. To

add pairs, go to the MODE menu and enable the appropriate pan copy.

Once panning is enabled in the ENG home screen, press the BUS Key to enter and highlight the PAN

routing matrix. Then rotate the MENU Knob to select the input you want to pan. Pressing the MENU

Knob will cycle the assignment as L, C and R to each input pair that was selected.

If you set prevent empty pan to ON in the advanced ENG menu you remove the blank option, leaving

only L, C, R.

Busses 1 and 2 -Left / Right Output

Panning matrix

Input trim

Output Busses 3 & 4 will follow the pan selections made

in the ENG Home Screen. Outputs 5 & 6 will NOT. Please

note that by default 1 & 2 are always enabled.

The pan matrix shows where each channel will be outputted to

the L=left, R = right, C= both. Pressing the MENU knob will

advance the selection – pressing and hold will go back.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 89 90

Keine Kommentare

Zaxcom Nomad Bedienungsanleitung Seite 77