Zaxcom Nomad Bedienungsanleitung PDF herunterladen (Seite 44)

MAIN MENU Auto-Mixer

Using the Auto-Mixer

• The Auto-Mixer menu can be accesses from the main menu. After the Auto-Mixer is enabled you can the

access the menu by pressing the A-MIX key on Nomad. Unless MP3 support is turned on, in that case the A-

Mix key toggles the MP3 recording marker.

• After your inputs are assigned to the Auto-Mixer the letter “A” will appear to the right of the meter for that

input.

• When that input is active the “A” will be replaced by a blue dot indicating that the input is being included in

the mix. If multiple microphones are opened at the same time Nomad will display a blue dot for each active

input.

• If return inputs (7-10) are being used the virtual fader will appear over the meters for those inputs. To adjust

the levels on those inputs press the Menu knob to highlight that fader. Then by rotating the menu knob will

adjust the level to that input. To advance to the next fader press the menu knob. Press the Back (headphone)

knob to return to normal operations or adjust the hardware fader for a different input. If any of the virtual

fader are being used the Menu knob must be held for 1 second in order to access the main menu.

• You will want to make sure all bus routing is cleared for bus that the Auto-Mixer is routed to. This will

prevent unwanted audio from mixing into the bus.

Please note that Auto - Mix will not be able to differentiate between a speaker’s voice and noise such as a hit to

the microphone. So if the noise is louder than the mic on threshold that will open the microphone as well.

Auto-Mix indicator

Active channel indicator

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 89 90

Keine Kommentare

Zaxcom Nomad Bedienungsanleitung Seite 44