Zaxcom Nomad Bedienungsanleitung PDF herunterladen (Seite 75)

NOMAD OPERATIONS ZaxNet Quick Start Guides

QRX IFB audio receive

1. From Nomad:

a. In the main menu, select ZaxNet Setup.

b. Scroll down and select input configure. To be able to use ZaxNet, make sure that input type is set to 8

or higher.

c. Power cycle Nomad.

d. Return to the ZaxNet setup menu.

e. Make sure IFB Mode is set to RX or TX+RX.

f. Scroll down to RX channels and select Freq 1 and choose which frequency you want to receive audio

on.

Tip: There are several smart phone apps, which will show you what Wi-Fi frequencies are being used

in your area. This can be useful in selecting an open frequency.

2. From the QRX:

a. Go to the IFB extended menu.

b. Set the IFB to TX and set the TX frequency to the same frequency that you set Nomad to.

3. From Nomad

a. Go to the headphone setup matrix and put a cross point in the corresponding ZNET matrix. To listen to

Freq 1 you will select the first box, Freq 2 the second, etc.

b. Now when you select that HP matrix you will be monitoring the audio being sent from that QRX. If you

have your IFB Mode set to TX+RX, Nomad will temporarily stop transmitting over ZaxNet and receive

signal while you are in that headphone matrix. When you leave that headphone matrix, Nomad will

start transmitting again.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 89 90

Keine Kommentare

Zaxcom Nomad Bedienungsanleitung Seite 75