Zaxcom Nomad Bedienungsanleitung PDF herunterladen (Seite 45)

MAIN MENU ZaxNet Menu

ZaxNet Setup Menu

Scroll for additional menu items

IFB Mode

• OFF - ZaxNet is off.

• RX - The ZaxNet transceiver is set to receive mode. You will be able to receive audio and time code from a

ZaxNet transmitter.

• TX - The ZaxNet transceiver is set to transmit mode. You will be able to transmit audio, time code and

wireless transmitter commands right from your Nomad. Please note if you set the IFB mode to TX, be sure

to attach a ZaxNet antenna. If you do not, RF can potentially leak into the microphone preamps.

• TX+RX - ZaxNet will stay in transmit mode unless you select to monitor audio via ZaxNet, at which point you

will go into receive mode. So if you set up one of your HP selects to monitor a wireless or a camera

mounted QRX via ZaxNet and you select that preset ZaxNet will go into receive mode (RX) mode to allow

you to monitor it until you deselect it.

Input Configure

To use ZaxNet you will need to set the INPUT CONFIGURE to 8 or higher to enable ZaxNet. See:

Input Configure page 36.

TX Channel

This is the frequency that Nomad will use to transmit IFB audio, time code and ZaxNet commands on. The

ZaxNet frequency range is from 2.403 to 2.475 GHz. All ERX receivers and TRX transmitters will need to be

set on this frequency.

RX Channel

This menu is where you can set the ZaxNet IFB receive channel frequencies for monitoring. You can chose

and monitor up to six ZaxNet frequencies.

When monitoring - the channel numbers

will correspond with the 6 headphone

selects in the HP setup matrix.

So for example “RX FREQ 1” will be the 1st

box in the “ZNET” select in the matrix and

“RX FREQ 2” will be the 2nd box.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 89 90

Keine Kommentare

Zaxcom Nomad Bedienungsanleitung Seite 45