Zaxcom Nomad Bedienungsanleitung PDF herunterladen (Seite 37)

MAIN MENU Mode Menu

Transport Keys

There are two ways that the multi-function keys can be set to control the way Nomad will go into record,

stop and playback.

Shifted Mode

If the transport key is set to shifted mode and you press the TC, A-MIX or ZNET key, the menu associated

with those keys will open. When set to shifted mode to go into record, playback or stop, you would need

shift those keys. To shift press the MENU knob while simultaneously pressing the REC, PLAY or STOP key.

While in shifted mode it is still possible to directly go into record, play and stop with a single key press by

pressing and holding the transport key for 1.5 seconds.

Unshifted Mode

If the transport key is set to unshifted mode and you press the REC, PLAY or STOP keys Nomad will go

into record, playback or stop. In unshifted mode to display the TC, A-MIX or ZNET menus, it is necessary

to press the MENU knob while pressing the TC, A-MIX or ZNET key.

GP Remote Roll Enable

Turning on the remote roll will allow Nomad to use a remote switch to start and stop recording.

To operate you will need to connect a toggle switch to the serial port on Nomad - not to the USB port.

For pin configuration please see the connector assignments in the back of this manual. Note that the GPI

remote roll cannot be used at the same time as Mix 8 / 12 or FP8 fader panel.

Pan Copy

If you are using the ENG Home screen pan matrix to assign inputs to output buses 1 and 2 creating a left

and right out assign - pan copy gives you the option to have output buses 3 / 4 and or buses 5 / 6 follow

the same pan selection. So the inputs that are assigned to busses 1 and 2 will automatically be assigned to

the busses that are being pan copied. This is useful if you are feeding the same two bus source to multiple

cameras.

VFader Cycle

Virtual fader will allow you to mix all 10 channels right from the ENG Meter screen. The MENU knob will

become the hardware fader for those inputs.

VFADER CYCLE lets you choose which inputs (if any) you want to be able to mix in the ENG Home screen:

• NONE

• Input 7 ONLY

• Inputs 7, 8

• Inputs 7, 8, 9

• Inputs 7, 8, 9, 10

Note if you need to access the Main Menu from the ENG meter screen while the VFader mode is active,

you will need to press and hold the MENU knob for approximately 1.5 seconds.

Shows which inputs will be active

when the Virtual Fader is activated

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 89 90

Keine Kommentare

Zaxcom Nomad Bedienungsanleitung Seite 37