Zaxcom TRX992 Bedienungsanleitung PDF herunterladen (Seite 73)

Zaxcom Digital Wireless System User’s Manual______________________________________Chapter 13

LED mode = LOW POWER MODE

TX Format = US (MONO)

(NOTE: no timecode, IFB or recording is available in this mode)

Changed battery meter table

===================================================================================================================

Version 5.00a: 2007-11-03

Added LED OFF mode in the LED Reverse page

===================================================================================================================

Version 5.00: 2007-10-29

Fixed TRX900 - swapped LOW1 / LOW2 display in the Pacifier page‟s remote power display

===================================================================================================================

Version 4.99a: UNKNOWN

Fixed IFB side autoload (would not go into STOP because it never really went into RECORD)

===================================================================================================================

Version 4.99: 2007-10-04

Added support for RCR dual mic side adapter

Changed stereo to always be ISO

Changed FORMAT_EUNB to FORMAT_MONO_R

===================================================================================================================

Version 4.98: 2007-09-25

Fixed IFB Autoload function (remote transport commands TXifb.NS_RemoteTPmode not being set)

===================================================================================================================

Version 4.97a: 2007-09-25

Changed sector size from 32k to 16k (or less) for Digital Foci PhotoSafe (FAT16 vs. FAT32 problem)

===================================================================================================================

Version 4.97: 2007-08-31

Fixed a serious bug regarding the RecoverOpenSegment feature. If the unit is powered down while in record, the next recorded segment could

begin at the start of the card, which would overwrite previous audio and make only that last recorded segment available.

The new ZaxConvert software (v5-97) fixes a minor problem with the RecoverOpenSegment feature and now appends the segment number (in decimal)

to the end of each generated WAV or MP3 file.

===================================================================================================================

Version 4.95: 2007-08-10

Added IFB Voting Enable page. Turn „ON‟ voting only if you have two IFB transmitters transmitting 2MHz apart from each other. If a receiver has

voting turned „ON‟ and it loses its IFB signal it will try to acquire an IFB signal on a channel that is 2MHz higher than its current RX frequency.

For example: set the IFB to receive on 2.403GHz and set up two IFB transmitters (far apart from each other) one at 2.403GHz and one at

2.405 GHz. The IFB receiver(s) will switch from one channel to the other if the IFB signal degrades. This feature dramatically increases the

IFB range when using two or more IFB transmitters.

Added Safe Boot Mode feature. If the unit crashes after boot (and the battery is OK), hold the MENU and DEC keys while powering up. This will

turn „OFF‟ the IFB. An older unit may crash if IFB and STEREO are both enabled. There is a modification to the power supply board that will

fix this.

=============================================================================

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 87 88

Keine Kommentare

Zaxcom TRX992 Bedienungsanleitung Seite 73