Zaxcom TRX992 Bedienungsanleitung Seite 27

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 88
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 26
Zaxcom Digital Wireless System User’s Manual_______________________________________Chapter 2
27
Transmitter Bootup Sequences
Standard Bootup Sequence (without any card inserted)
LCD
SYNTH AB
LOWER POWER MODE
IFB IS OFF 0
(OPTIONAL PAGE: Only appears if Low Power mode is fully enabled.)
PCB REVB BBBB
VER A-AAA (CC)
(PCB REVB Indicates the printed-circuit board is revision “B”.)
(AAAA Indicates the currently installed firmware version.)
(BBBB Programmable logic device revision code.
„0000‟=no timecode input „0150‟=timecode input available.)
(CC Indicates which options are available:
00=none, 01=Record, 02=IFB, 03=IFB & Record.)
PRESS MENU
TO START
Optional pages
None or one of these
is displayed based on
Boot Up Mode page
{p.42}.
(Only appears if the unit is set to:
STANDBY.)
RUNNING
(Appears after you press the MENU key.)
(Only appears if the unit is set to:
REMOTE STANDBY.)
REMOTE STANDBY 0
^ + MENU = EXIT
***NO CARD***
NAME:
DDDDDDDD
(DDDDDDDD Displays the “Name” entered in the Extended Menu.
The initial default isSN:, followed by the unit‟s serial number.)
DSP SPEED=98
(This page displays the Digital Signal Processor clock rate in MHz. The
typical value is 98MHz.)
ENCRYPTION IS ON
(OPTIONAL PAGE: This statement indicates the Encryption Code
page {p.44} has a code. Verify the code matches the receiver‟s code.)
REMOTE CTRL=OFF
(OPTIONAL PAGE: This is a reminder that the Allow IFB Remote
Control page {p.43} is set to “Off”. Should it be off?
AUDIO
(This page indicates the Audio processor is starting.)
ZAXCOM VA-AAA
WWWWWW SN:ZZZZZ
(WWWWWW Indicates what hardware is being initialized.)
(ZZZZZ Indicates the unit‟s serial number.)
(Be aware, if you get either of these alerts,
the unit will not go into RECORD mode.)
581.6
STOP
(The outline of the battery symbol starts blinking when the voltage
reaches a low level.)
LOW BATTERY
1.60V
(This page appears, when the battery HAS to be changed.)
Table 2-7 Standard Bootup Sequence (without any card inserted)
Seitenansicht 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 87 88

Kommentare zu diesen Handbüchern

Keine Kommentare