Zaxcom TRX992 Bedienungsanleitung PDF herunterladen (Seite 47)

Zaxcom Digital Wireless System User’s Manual_______________________________________Chapter 3

Dual Color LED

The dual color LED on top of the unit indicates the recorder‟s transport status:

Color

Indication

Solid Green

STOP mode or PLAYBACK mode (displays when no card was

inserted)

Green and flickers Red

RECORD mode

Solid Red

Recording connection lost. The card may have been ejected, is

full or was not formatted correctly.

Table 3-2 Recorder LED Indications

NOTE: The colors for Stop and Connection Lost are determined by the selection made in the Error!

Reference source not found. {p.Error! Bookmark not defined.}. Start the unit without a card installed.

If the LED is red, pick the other LED ON (NORMAL) selection.

Recording Operation

This section describes the steps necessary to record audio.

Formatting the Media Card

Many cards are sold preformatted; however, you must reformat it in the recorder prior to recording on it. Only

cards formatted in the unit will work correctly.

To prepare a card for use, or to erase the contents before reuse, perform the format procedure on the Format

Recording Card page {p.38}.

Upon completion of the formatting process, the following files remain on the card (example based on a 2GB card):

SN01752 (This folder‟s name initially defaults to the unit's serial #, thereafter it uses

what was entered in the Track Name page {p.44}.)

ZBLK0000.ZAX (size = 1,048,576 KB)

ZBLK0001.ZAX (size = 932,684 KB)

ZDIR.ZZZ (size = 538 KB)

DELETE.ME (size = 512 KB)

The ZBLK****.ZAX files store the recording segments, and the ZDIR.ZZZ file stores metadata about each

segment (i.e.: pointer into the .ZAX file, associated start timecode, track name, etc.)

The DELETE.ME file can in fact be deleted. Doing this frees up enough room for a copy of the firmware.

CAUTION: Do not delete any other files from the card. Doing so will prevent it from working correctly. If for

some reason you proceed to delete the wrapper files, follow the instructions To Recreate the Wrapper

Files (will not destroy existing audio takes): {p.38}.

NOTE: If you move a unit from one actor to another actor and enter the new actor/character name, the folder

name will remain the same and any audio from the new actor will be stored in the same folder. The metadata

will contain the correct name.

IMPORTANT: If it is important to you that the Track Name folder is correct, prepare a card for each

actor/character and have it follow each actor. This does not eliminate the need to change the track name, so

the correct name appears in the metadata.

Current Timecode and Frame-rate Display

The current timecode generator value and frame-rate appear on the TC Frame-rate page {p.33}.

Jamming Timecode into the Unit

While the unit is being jammed, it identifies the timecode rate and type, and sets itself to that rate.

NOTE: The unit‟s timecode accuracy is approximately 1 frame in 6 hours (1.54 PPM).

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 87 88

Kommentare zu diesen Handbüchern

Keine Kommentare

Zaxcom TRX992 Bedienungsanleitung Seite 47

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mikrofone Zaxcom TRX992