Zaxcom TRX992 Bedienungsanleitung PDF herunterladen (Seite 31)

Zaxcom Digital Wireless System User’s Manual_______________________________________Chapter 2

Common Transmitter Standard Menu

Pacifier page

581.6

12H

STOP

581.6

RXG

REC

581.6

R#!

STOP

LOW2

REC

581.6

37M

STOP

MUTE

Page purpose: This is the default page after startup and displays the following information:

transmitter frequency • remaining battery capacity • available recording time

IFB receive indicator • recording mode • audio input level

recording buffer overrun • current power mode

Press the INC or DEC key to temporarily display the current battery voltage in place of the battery icon.

Power Modes (requires REMOTE CONTROL OPTION), indicated by the frequency field:

581.6 – When the transmitter frequency is displayed the unit is fully powered up.

LOW2 – The RF Power Amplifier, RF Board and Mic Pre-amp are all disabled.

NOTE: It is not possible to remotely power-down only one TRX9xx unit. It is an all or nothing event.

Receiver/Recorder status appears to the right of the frequency:

###H or

##M or

##S – Indicates the remaining available recording time in hours, minutes and finally seconds. This item is

only displayed if a media card is available for recording and the Recording Mode page {p.42} is

set to NON-LOOP RECORD (requires RECORDING OPTION).

RX – This flag will be displayed alternately with the remaining recording available recording time, if the

IFB100 is running and the TRX9xx is receiving it (requires REMOTE CONTROL OPTION).

NOTE: The RX flag indicates that an IFB100 is being received on the IFB frequency you picked. It is

possible to receive IFB audio from another transmitter within range, even if it does not have the same

Group ID. IFB audio is the only transmission between the IFB100 and TRX9xx units that does not use

the Group ID as a filter.

G – Appears to the right of the RX flag (requires REMOTE CONTROL OPTION):

o Only when a Remote Audio Gain Change page command is received from the IFB100.

o Continuously, while ZaxNet is enabled for this unit.

R#! – Recording buffer overrun indicator (# = 1 to 9). If it reaches 9, the recording will stop; this means

the card is too slow or has been removed (requires RECORDING OPTION).

MAX! – Occurs either when the 254

take is currently being recorded or when a card is inserted that

already has 254 takes. That is the maximum number of takes that can be recorded on one card,

no matter how large or small it is (requires REMOTE CONTROL OPTION).

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 87 88

Kommentare zu diesen Handbüchern

Keine Kommentare

Zaxcom TRX992 Bedienungsanleitung Seite 31

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mikrofone Zaxcom TRX992